Opis
FXCONNECTX FX PRO zestaw bezprzewodowy do gitary odbiornik + kontroler
With FXConnectx, no longer are long tone-killing, troublesome cable runs required to connect and control effects to a rig or sound board.
With FXConnectx, all cable runs can be VERY short and everything can remain inside a protected rack. As an example, a 20 foot Send cable to a floor board and a 20 foot Return cable back to a rig totals 40 feet of audio signal/integrity loss and chances for connection troubles. With FXConnectX in your rack, 40 feet of cable can now be reduced down to 12 inches or less, but you can be a few hundred feet away!
The FXConnectx system consists of a Wireless Control System (Stage Pro & Studio pro lines) and one or more peripherals (Wireless Body Pack Controller or Wireless Pedalboard). These peripherals are used to wirelessly switch the audio effects from EQs, pedals, processors, etc. The amount of devices you can control depends on the amount of channels available on the FXConnectx system you purchase.
The FXConnectx System has been designed to provide wirelessly controlled True Bypass Analog „Transparent” Audio Switching technology for pedal boards, guitar/audio racks, recording studios, or any application up to 275 feet in distance! There is nothing else that compares to the sound quality, speed, flexibility and simplicity that FXConnectx has to offer musicians, vocalists and sound engineers alike!
It’s not complex to use or expensive, just engineered to do the job and do it right! We’re musicians too! That’s how we came up with the idea!
Do you own „vintage” pedals or pedal that are not „true” true-bypass? Well, unless your effects or anything else in the chains between your guitar and amp is not true-bypass, then they are altering your instruments tone in a not so good way! Vocalists, this applies to your „instrument” as well!
First, you have to run long cables out to the stage (or studio) and back again (long cables attenuate your instrument’s signal, gets in everyone’s way and always fails at the wrong time – during the show of course!).
Then, chances are that some (or all) of your pedals use a transistor or JFET to switch them on and off (not true-bypass), again, sucking up your tone! No more!
Stage Pro 8 Channel
FxConnectx Stage Pro- 8 channel system is designed to simplify and expand upon the performance & recording possibilities of musicians who want to be true wireless and use multiple effects that typically have a pedalboard full of gear and cables. Flexibility and simplicity is the key. The Stage Pro-8 Channel system is equipped with 4 true bypass analog channels in addition the system offers an A/B Channel Switcher, Full System Mute, and a 2 Tap/Tempo controllers, in board Klick Killer, Buffer switch for vintage pedals and much more.
For the guitarist/bassist your effects and wires stay safely off stage. You can drop multiple wireless floor controllers anywhere on the stage (or off the stage) without running wires or power. Simple setup. Turn them on and go.
Instruments can be outfitted with Body Pack controllers that can be used when away from the floor units or even backstage. Each guitar and backup guitars can have their own controller attached to the strap and ready to go.
When used by the vocalist you are now in full control of your own effects (echo, verb, harmony, etc…) with the press of a button or stomp of your foot – you are in control. Freedom of expression and freedom to improvise.
Key Features offered within this line of products:
„Freedom, Simplicity, Flexibility”
- Proprietary FXC True Analog Bypass Transparent Wireless Audio Switching Controller.
- 100% True-Analog Proprietary signal path is equivalent to less than 12 of high quality studio audio cable.
- FXC proprietary Custom Microprocessor Algorithms ensure the fastest, latency-free system operation available
- FXC Proprietary FCC certified internal 2.4GHz receiver interface.
- 4.2 Billion Security Codes ensures secure operation across the globe.
- Exceeds 275ft in wireless range.
- Custom FXC noise-canceling discriminate technology ensures interference-free operation.
- Proprietary FXC Custom Engineered Klick Killer to reduce clicks that common pedals suffer from.
- Proprietary FXC Buffer switch for vintage analog pedals.
- Proprietary FXC Learn Function. Ability to Learn up to as many wireless pedalboards or wireless body pack effects controllers as needed.
- Proprietary Failsafe Protection Feature (Audio pass-through during power loss/unit powered off).
- Proprietary wireless FXC Patch programing, scenes and bank memory selections: Eliminate tap dancing.
- 8 True-Bypass configurable channels.
- Each channel is configurable for 3 modes of operation: Patch Banks (Eliminates tap dancing as with conventional pedals), Momentary (for fast action like tap tempo) and Toggle (like a standard On/Off pedal).
- Remote Dip Switching: Set each wireless controller to control specific effects pedals and rig settings
- 100% Passive Analog signal path
- Audio path effectively remains Hard-Wired at all times, never digitally manipulated.
- System mute function
- Audio MUTE using our custom Soft Mute system
- Wirelessly control Tap/Tempo
- A/B Channel Switching.
- Control amp channel switching. A/B, Clean/Dirty, Etc…
- Easily consolidate commonly stacked/chained effects into groups for quick, one-step switching. Eliminates multiple stomps Tap Dance.
- TAP feature allows wireless control of tap/tempo features of echo, delay, and looper pedals.
- FXC uses only the Highest Quality input & output jacks.
- All ¼ jacks are secured in place soldered to ensure long service life and NO solder fractures.
- ¼ Normally Open or Normally Closed switch interfaces for A/B or similar switch control needs.
- Powered by a Regulated supply that is Dual Stage Filtered and Regulated for stable, quiet, and noise-free operation.
- Systems can offer MIDI control with custom orders.
- Each unit is assembled by hand and factory tested to the highest standards.
- Made and Engineered in the USA.
Wireless Pedalboard 8 Channel
f you are reading this then you are Just like Us and also one of the many that are tired of being stuck to one stationary location, being tethered to one pedalboard, you are sick of your excessive break down and set up times, long cable runs, tap dancing, audio tone sucking challenges and much more!
FxConnectx has developed, engineered and offers solutions to everything mentioned and much much more!!
FxConnectx is your Audio Solutions Industry Leader In Analog True Bypass Wireless Control!
FxConnectx Wireless Pedalboard systems are designed to provide wirelessly controlled True-Bypass Analog Transparent Audio switching technology to control effects pedals, rigs, boards, guitar/audio racks, recording studios or any other application up to 275 feet in wireless range. NOW! FxConnectx Wireless Pedalboards
Simply place as many FxConnectx Wireless Pedalboards as you want or need around the stage, arena, rehearsal space or recording studio, turn them all on and you are now free to roam around wirelessly with full control!
Used by Professional Guitarist, Bassists, Vocalists, Recording Studios and Live performances there is nothing else that compares to the control, speed, flexibility, expandability that FxConnectx Wireless Pedalboards deliver to the industry!
No longer have long set up and break down times, no longer trip over long cable runs, get your full tone, no longer be subject to one stationary location, no longer tap dance. Cut the Cord and become truly full wireless with FxConnectx and get all of what you have long been missing. Control your effects pedals and rig wirelessly when and where you need it!!
System Features
- Compatible with all FxConnectx Wireless Body Pack Effects Controllers
- FCC certified internal 2.4GHz Custom Proprietary Transmitter Interface.
- 4.2 Billion Security Codes ensures secure operation across the globe
- 275+ wireless range
- FXC Custom Sync Control Microprocessor Algorithms ensure accurate timing and synchronization with the wireless main unit.
- Proprietary Failsafe Protection Feature (Audio pass-through during power loss/unit powered off).
- Programmable mode control (Patch, Momentary, or Toggle)
- Remote Dip Switching to set each wireless controller to control specific effects pedals/rig settings.
- Patch programing, scenes and bank memory selections: Eliminate tap dancing.
- TAP feature allows wireless control of tap/tempo features of echo, delay, and looper pedals.
- Easily consolidate commonly stacked/chained effects into groups for quick, one-step switching.
- Eliminates multiple stomps Tap Dance.
- Transmitter activity indicator
- 8 tactile switches dedicated to True-Bypass Analog channel control
- 8 tactile switches dedicated to channel control
- 1+ A/B Channel Selector
- Control amp channel switching. A/B, Clean/Dirty, Etc…
- System Audio Mute Switch
- Audio MUTE using our FXC custom Soft Mute or Hard Mute system
- 2+ Tap/Tempo Controls
- Rigid lightweight aluminum enclosure.
- Low battery light detection
- Powered by a single 9 volt alkaline battery
- Each unit is assembled by hand and factory tested to the highest standards.
- Made and Engineered in the USA.
